Measurement tools snap at 45 and 90 degree angles

This article applies to:

  • Revu 21
  • Revu 20
  • Revu 2019
  • Revu 2018

Problem

When placing a measurement on your PDF, lines snap at orthogonal angles (45 and 90 degrees) as you move your cursor.

Cause

This issue occurs when the Snap Orthogonal option is enabled in the Measurements panel.

Solution

Follow the steps below to disable Snap Orthogonal.

  1. To open the Measurements panel, select Window > Panels > Measurements.
  2. At the top of the panel, select the Measurements dropdown.

    Disable Snap Orthogonal in Measurements panel

  3. Toggle Snap Orthogonal to disable it.
    If you’re using Revu 2018, the Snap Orthogonal setting is available at the bottom of the Measurements panel under Options.

If the issue persists, double-check your snap settings in Revu > Preferences > General > Grid & Snap.

Revu 21

Revu 20

Revu 2019

Revu 2018

Troubleshooting

If your cursor snaps at 45 and 90 degree angles, which limits you while placing measurements in Revu, here’s how to fix it.

Related Articles