Measurements Tab

The Scale section sets the document scale and measurement precision. To ensure the accuracy of measurements, takeoffs, and so on, check that the scale is set correctly.

Separate Vertical Scale: Select to define separate X and Y scales. See Calibrating Separate X and Y Scales for more information.

Independent Units: Select to define independent units of measure for area and volume measurements. When selected, Area Unit and Volume Unit dropdown menus will appear. Select the desired measurement units from each. When not selected, these measurements automatically use those established in the document's scale.

Scale definition: The current scale is shown in the form (Measurement A) = (Measurement B). These can be changed manually, if desired, though calibration is usually recommended as sometimes scaling occurs during the PDF creation process.

Precision: Defines the decimal or fractional precision of the measurement values.

Calibrate: Calibrates the document to allow accurate measurements to be taken. See Calibrate for more information.

Recalculate: Recalculates existing measurements after the precision or scale has been changed.

The Measurements section controls labels for new measurement markups and reports information that can be helpful while taking measurements.

Subject: Defines the subject for the selected measurement markup. If no measurement is selected, it defines the Subject for the next measurement markup placed. Subject is reported in the Markups list; giving similar markups similar subjects can make them easier to work with in Markups list.

Label: Defines the label for the selected measurement markup. If no measurement markup is selected, it defines the Label for the next measurement markup placed. The label is reported in the Markups list and appears on the markup itself by default.

Depth: Defines the depth for Volume, Area, and Perimeter measurements, which is used to calculate volume and wall area. Can be set before placing the measurement (but after an applicable measurement type is selected) or after selecting an existing markup.

Width: Shows the width (to scale) of the measurement. For the document width, see the Layout section of the Properties tab.

Height: Shows the height (to scale) of the measurement. For the document height, see the Layout section of the Properties tab.

Slope: Describes the slope ration for the measurement, allowing for accurate calculations of materials over a sloped plane. To set a slope, select a unit of measure for it (Pitch, Degree, or Grade) and enter the value in the corresponding field.

Scale: Shows the scale of the selected measurement markup or Viewport. If none are selected, the scale of the current document is shown.

Current and Total columns: Shows the sums of the of the measurements taken so far. Click Clear to reset these accumulators.

The Options sections contains other options pertaining to measurements.

Make Annotation: When checked, measurements are created as permanent annotations on the document. When unchecked, measurements are temporary. This function is only available for Studio Session PDFs.

Snap Orthogonal: Restricts measurements to angles in 45° increments. This can be temporarily enabled by holding down SHIFT.

Snap to Content: Snaps the cursor to the underlying lines and drawing elements, making it much easier to accurately select 2 points. Only snaps to vector content in a PDF file. Will not snap if the content is an image or a scanned file. The cursor will change to include a shaded square when it is over an element that can be snapped to.

Use Embedded Scale: Applies the scale defined in the document when measures are created.

Highlight Viewports: Causes any Viewports on a page to be highlighted in blue anytime a measurement tool is selected.